-
### Describe the bug
Hi，I have written a code with PX4 1.14 to do a simulation on gazebo,like this: uORB::Publication _trajectory_setpoint_pub{ORB_ID(trajectory_setpoint)};
### To Reproduce
but it…
-
### What happened?
Thermostat turns on (opens valve) on occupied heating setpoint change even when system_mode == off but doesn't change the system_mode. So the valve is open, heater is heating, but …
-
If you use "Normal anchor" and select anything other than "Bottom Right" as your point in TipTac Options, you get code conflict with:
FrameXML/GameTooltip.lua
Line:161
Ref: [https://github.com/to…
-
Problem related to all versions, I'm using 2.5.59.13.
parameter
filament_max_volumetric_speed
should be a limiting factor for all speeds of all printing movements
- works as intended
paramet…
-
### Reproduction steps
Default Max Cool/Heat Setpoint:
Heat = 3000
Cool = 3200
Commission Thermostat
Set occupancy heating setpoint to 2000: ./chip-tool thermostart write occupied-heating-set…
-
Whenever i called AIO.Handle("AIOExample", "print") from a client event handler my print function on the server side got called twice.
But the client side event handler only got triggered once.
I…
-
Hello,
I'm having trouble communicating with a mass flow controller via Ethernet/IP. In my application, I want to read and write data. I was able to successfully read data using generic_message. How…
-
### Before submitting a new issue
- [y] I [redownloaded the latest release](https://my.home-assistant.io/redirect/hacs_repository/?owner=signalkraft&repository=mypyllant-component) and restarted Ho…
-
Hi, I have a MCF SFC6xxxx device using RS485
When I sending the command following command to the device:
0x7E, 0x0, 0x0, 0x1, 0x1, 0xFD, 0x7E
It sends back:
**0x7E**, 0xFE, 0xFF, 0xF9, 0xF9, 0x…
-
The target setpoint seems to be controled by the sketch.
Is it possible to send via Home Assistant / MQTT what temp tou want the boiler at (i.e 40hr), or is this always detrimed by the sketch. Ive …