-
To be brief, I was wondering how Moppy could be extended to be used directly with stepper motors. I am currently using 4 NEMA-17 Stepper Motors with an Arduino and 2 Adafruit Motor Shields. Has anyone…
ghost updated
7 years ago
-
I am using a Filametrix on a standard bedslinger (OG Ender 3) but the X axis stepper skips at normal printing current.
I have edited the MMU_CUT_TIP macro to adjust my stepper current before and a…
-
Rover-3.5 supports Balance Bots (aka segway like vehicles) but we could achieve better performance by adding support for [stepper motors like these from pololu.com](https://www.pololu.com/category/87/…
-
-
Make it so that the motor cannot go beyond the range of the actual machine and break it.
-
Need a viable replacement since those motors are no longer an option.
-
I was working on Arduino Uno using TMC2209 to run a stepper motor and to control it's current using UART, but the current is not being set at all with rms_current(). I've checked the wiring and it's a…
-
Hello. I will repeat my question here, because this topic is closer.
> Hello dear developers! Can I ask you to make examples on servo or stepper motors control? Ideally, these are blinds. PLEASE! T…
-
Hi,
I realizaed that randomly while printing, the steppers start to make noise and become very very hot, more than 80C (untouchable).
After lots of reading and tests, i think the problem comes w…
-
I would like to use it with DRV8825 or with an A4988.
Thanks so much for the software