-
- Seen in version (release version or githash): 2016720.1
- On flight controller (if applicable): Sparky 2
Issue details:
Sparky2 FC does not recognize FlySky ia10 receiver connected to RCV port.
Con…
-
I recently acquired a brushed sparky 2 and a hawkeye UHF RC system that attaches to taranis X9D. I followed every step on the github (https://github.com/TauLabs/TauLabs/wiki/Brushed-Sparky) to the poi…
-
I have played a bit with Luxfloat. So far I like it very much. But in angle/horizon mode the quad reacts very slow. I tried to play around with ROLL & PITCH rates. In horizon this has the desired effe…
-
`make all` gives this error:
``` bash
*NOTE* Sanitized disallowed variable 'TMPDIR' from environment
/usr/bin/sh: line 1: qmake: command not found
makefile:317: recipe for target 'uavobjgenerator' …
-
I am building the brushed sparky 2 right now and I was wondering whether I can solder the 1S battery to the quadcopter directly without the connectors. If I can do so, where can I charge the battery?
…
-
TauLabs flight control firmware is amazing and everybody should use it. However, other than BrainFPV, there's not really a good OSD available. I think MWOSD is an excellent option.
I've been develo…
-
In the osx version of 1.6 i don't see dronin in config.h
I used Taulabs msp instead, this gives inconsistent altitude.
Is support for Dronin coming in a next release?
Thank you very much for your v…
-
Barometer and sonar al no loger shown on my NAZE32 with the RC3 on version 1.2.0.
![screenshot - 29_08](https://cloud.githubusercontent.com/assets/15327312/18057952/6b0ba1c0-6e12-11e6-8668-819e0c879a…
-
Hello Opentx comunity,
I Devolop one script Luapilot for Arducopter,Arduplane,PX4,Cleanflight and Taulabs, Naza
In Simulator everthing is fine but when i load it to the Radio its say low Memory...
…
-
From here: https://forum.dronin.org/forum/d/28-smartport-telemetry-on-lux-flight-controller/12
> I'm running OpenTX 2.1.8 on the transmitter.
>
> Yeah it seems like the problem is isolated to senso…
mlyle updated
8 years ago