-
### Bug Report
I'm using Marlin v1.1.6 with RAMPS 1.4 with full graphic Smart Controller. I've changed from a thermistor to a thermocouple K-type using a MAX6675. I've changed the sensor type to -2 i…
-
hi to all
am i using a cyclops extruder with two stepper motor that they push the two filaments in to the cyclops extruder.
the problems are:
1)if i set 2 extruder with single nozzle function,it'…
-
There is a board on ESP32. Compiled the firmware based on Marlin 2.0.9 and Esp3dlib. But there is no connection between the WEB interface and the firmware. A similar GR BL firmware works on this boar…
-
@jordens Please have a look at the CPU signal assignments.
It should be coherent with the STM32MX project
[Thermostat_8CH.zip](https://github.com/sinara-hw/Thermostat_EEM/files/5454705/Thermostat_8C…
-
### Bug Report
**- Description:**
After issuing the `G29` command to use the Bilinear Leveling feature, the printer does not react to either the `M851` command nor to a change in the `Z_PROBE_OFFSET…
-
Hello.
Forgive me as I am newer to marlin and I feel this issue has a simple solution.
I have upgraded my tronxy x5s to use arduino Ramps 1.4 combo with Tmc 2130 stepper drivers with the setup f…
-
Im trying to install an Aibecy Anet 12864 LCD Smart Display Screen Controller on my Anet a8 and im getting errors after i enable "#define DOGLCD" and im getting this error "'DOGLCD_CS' was not declare…
-
### Bug Description
I got a problem with Anet a8 plus, My capacitieve sensor goes outside my bed to measure, when I try to auto level.
I use marlin 2.0 and search everywhere for the solution. …
-
Is it planned to support the work through the JSON, and RepapFirmware?
-
Marlin 2.0 Thermocouple k-type with AD595 RURAMPS + Arduino Due
When the temperature increases, the readings issued by the firmware, on the contrary, decrease. On Repetier Firmware works correctly