-
I'm trying to scale up each module so they can be readable from further away, I think I'll get each A6 card by cutting some A4 sheets into 4 ([aliexpress link](https://www.aliexpress.com/item/ID-card-…
-
I don't know how to connect to the motor, and what is the relationship between the pin parameter in the set_pin_mode_stepper function and the motor connection?
thanks!
-
I have built the board, I believe everything is soldered cleanly and in the correct orientations. WE (my boss and I) used Atmel Studio 7 to compile and we have the ATMEGA328P selected for the chip. Ev…
-
Hi friend, could you explain the code for your home sensor? I'm using a nema 17 engine instead of yours. I want help to understand the code of your home sensor. Could you explain me. Congratulations o…
-
I have been working on Pan/Tilt platform for my Sony camcorder using PI and following inexpensive motors.There will be 2 motors for pan and tilt.
https://www.ebay.com/itm/ULN2003-28BYJ-48-5V-St…
-
### Description
Hello I have a DIY 3d printer which has E3d v6 hotend.. when I load file and give print in pronterface the printer starts but the hotend temperature never increase it simply fluct…
-
Dear Arduino Staff, please add PaunaStepper Library for Arduino Library.
PaunaStepper is a library for use with hobby stepper motors. It is mainly oriented to low-cost stepper such as model 28BYJ-4…
-
### Hardware:
Board: ESP32 DevKit V1
Core Installation/update date: Don't know where to look
IDE name: Soebler (Eclipse)
Flash Frequency: 80Mhz
PSRAM enabled: …
-
Although there is TinyStepper_28BYJ_48 in LIB, it cannot be compiled correctly. An error will be reported. In file included from /tmp/948630601/Walldraw/Walldraw.ino:9:0:
/home/builder/opt/librari…
-
You can read some more info on the cheap yet worthy 28BYJ-48 stepper motor **here**.
--------------------------------------------------------------------------------------------------^
Dead link.