-
~~Stock mainboard can be supported by running Klipper, Mainsail, and Fluidd off of the original Mediatek MT7688 running a somewhat modified OpenWrt installation. This requires a good understanding of …
-
I've been talking with @Fragmon a bit about their Kobra work today and an interesting find came up: Bltouch probes don't work with the clock speed set to 200mhz. Flashing a 200mhz config shows a 168mh…
-
I just recently got the SKR V1.3 for the wiring simplicity and 32 bit stuff. Sadly, this has also created a few issues. The SPI jumpers are in the correct places and the +5V is in INT like it is suppo…
-
all three marlin tango revisions seem to be the same 1.1.8 and seem to be setup for a delta.. i'm fairly new to marlin, and i am trying to get my new board running on a cartesian, and currently i am g…
-
Hello,
I have a problem with the part cooling fan. It won't start or update the speed until one enters and exits various menus.
If I pushes the knob to enter the menu during the print, the fan s…
-
I've spent hours working with FLSUN to fix the firmware for my custom QQ-S Pro with an MKS Robin Nano V3.1 and a TS35 V2.0.
I have the Homing fixed except, if I offset any axis by a small amount ma…
-
### Bug Description
This is `bugfix-2.0.x` commit d84aff701e10a49d5ccc69ce323fdb0fdb84b6db
Long travels exhibit stuttering movement when ABL is configured and enabled.
If I switch ABL off by …
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
Hiho,
i'd had a look into the src, and tried to figure out where the actual licensing issues were located. And how much effort it would be to get rid of the licensing issues. But i'm pretty sure so…