-
How to use wifi in my device?
My wifi chip is:
```
SV6256P
TAC2309
1RA96B
```
Can't get wlan0 in `ifconfig -a`:
```
eth0 Link encap:Ethernet HWaddr 1A:19:24:50:9A:DE
in…
-
```
U-Boot SPL 2013.07
Board info: T41NQ
apll_freq = 1104000000
mpll_freq = 1440000000
vpll_freq = 1188000000
sdram init start
DDR clk rate 720000000
DDRP_INNOPHY_PLL_CTRL: 00000028
DDRP…
-
Hi folks!
I have a T31N that I accidentally partially flashed the wrong binary to the bootloader, now I'm unable to get anything from UART or anything in cloner for recovery.
When I connect UART…
lwis updated
6 months ago
-
# Introduction
Currently it isn't possible to get the motion detection events from Majestic streamer from 3rd party applications. The solution of running a "motion-detect" example from Hi3516EV200 M…
k1x0r updated
4 months ago
-
I'm trying to hack the XiaoFang 1080p camera (i.e. this: http://www.gearbest.com/ip-cameras/pp_487830.html)
I've got root access over serial and worked out what filename to include on the microSD (…
-
Hi there! Thanks for your work on this. I've got a 2MP PTZ Dome with this "ipcam.xin" firmware
```
Device Type: C6F0SgZ0N0PhL2
Software Version: V18.1.31.11.18-20210421
Webware Version: V3.0.7.1…
-
the module is jco h42 the cpu is ingenic t31n,cmos sensor is jxq03,at the first I try to flash it use the openipc official mothed,but failed,then I flash it use a ch341 programmer to do it well,it can…
-
- My goal is: In the MQTT client, I need to unsubscribe topic
- My actions were: I create a function
```c
void mg_mqtt_unsub(struct mg_connection *c, const struct mg_mqtt_opts *opts) {
…
-
please answer about my question.
no sudo command???
```
sudo
-sh: sudo: not found
```
install rtl8188fu & rtl8812au???
```
root@openipc-t21:/mnt/mmcblk0p1# ls
System Volume Informat…
-
1. Стабильный segmentation fault при изменении значения anti fliker
2. Релоад конфига вызывает зависание стримера, по логу врде бы все ок, но картинка уже не отдается, кильнуть процесс можно только с…