-
Hi,
Thank you for sharing your works.
I downloaded the code and I trained with objects room or used the pre-trained weights. It shows the same error as below:
data_config: datasets/multi_obj…
-
你好,最近利用你写的脚本BSA进行分析,用的果树F1代群体,但是用f1参数过滤后就只有一两个染色体上有数据了,换成其他群体过滤就正常,不知道具体是什么原因,请教一下,如果能给一个联系方式交流就更好了
-
```
The Marlin version RC7 - 31 Jul 2016
Machine Self build coreXY
Electronics board ramps 1.4 with arduino 2560
Machine components (direct drive e3d lite, with termistors (my stepper drivers are m542…
-
When building something large, it's nice to buffer all the materials for the project close to where it will be built. It lets you build all the parts gracefully and move them to where they will be us…
-
Hello, i'm having An issue when i upload Marlin 2 to my Skr2.0 revB with 2209 stepper drivers. Printer is a tronxy x5s corexy model. I can move all Axis, however X and Y only move diagonally. Corexy …
-
I just upgraded my Prusa I3 to RC8 and got problem with G29. I also tried RC8 BugFix but same problem. I can do 28 homing and it´s working good but when i start the leveling with G29 it goes to the fi…
-
how would one go about adding support for a SAM3X8C based controller?
I have the pin configuration file. I'm just not familiar with 32 bit controllers and don't quite know where to start.
https://gi…
-
with the new version of jyers the nozzle temps extremely fluctuating between 190 -210 by an setted tem of 200.
i have done a pid tunnig , its done ok but after saving the fluctuating nozzle temp also…
-
### Description
I just downloaded the latest version (1.8.9) on my Linux system (Debian 10 Buster, currently oldstable), and in all themes characters like 🎬 in the tutorial cannot be displayed. Inste…
-
The update to musl 1.2.2 did not cause any issues so far, just leaving this as a general observation, so 👍
So this issue could probably be closed if the following is expected.
I noticed my wasm b…