-
Hello
I have the omnibus f4 pro v2 flight controller board (black one) which I had ordered from https://robu.in/product/omnibus-f4-v2-pro-flight-controller/
I have connected my ublox neo m8n GPS an…
-
I found a problem with the starting order if two lis3mdl sensors are available.
Version: stable branch
In QGroundControl PREFLIGHT FAIL: MAG 1 SELFTEST FAILED showed up, so I tested some things.
Co…
-
Hi there!!!
Today i received my new GPS that i would like to install on my flying Wing controlled by a Omnibus F4 V3 (https://www.banggood.com/Eachine-Wizard-X220S-FPV-Racer-Customized-Version-Omnibu…
-
Hi,
I would just like to ask a few questions please.
Does your Particle board come with the GPS module from Particle or are you using a different GPS module with this project?
With your project…
-
Using the latest stable release of PX4 and latest stable release of QGroundControl, "Mag sensor inconsistent" errors pop-up as pre-flight checks fail.
When doing the calibration with a 2018 August QGC…
-
Hello,
In Omnibus F4 pro v2 (clone), I have 3 UARTs and they are used as below,
UART1-IBUS Rx
UART3-Compass SCL/SDA
UART6 -GPS
I see two pads above MOTO_VCC and as per https://github.com/iN…
-
I have now tried 2 different brand new Holybro Micro M8N GPS Modules and they both do the same thing that's why I think this must be a setting or issue with iNav - please see video:
https://www.you…
-
I have been testing this soft on a TTGO T-Beam T22_V05 (ESP32+NEO-M8N+LORA32_SX127x?) and I have not achive the ABP join...
- in config.h I write NewSkey, AppSkey and DevAddr as TTN show them:…
covra updated
6 years ago
-
omnibus f7
INAV/OMNIBUSF7 1.8.0 Nov 1 2017 / 06:59:03 (912d1315)
ppm (pe13) does nothing.
also testing neo m8n + mag akm8975 on RX3 TX3 (sda scl) nothing gps half on RX6 TX6 works.
have photo o…
-
hi i'm using f3 seriously dodo FC with ublox m8n gps/mag ,firmware version 1.6.1
everything works properly at first but after a couple minutes i get i2c errors over 20000
and cpu load over 900% the …