-
Hi, when i run nrf24-scanner with crazyradio PA it keep scanning without showing and result.
i reinstall pyusb as suggested in one of the tickets, also tried to flash crazyradio firmware and set the …
-
Hey,
I have setup two LoRa Modules and I am able to configure the module. (state = 0) for all configuration options. However, I am unable to send or receive packets. I am using the code from https:/…
-
I thought that 3.3v output PIN cab be used to drive some other sensor or something like that,but it doesn't have enough juice to drive sensors.
So I put the pin to good use by connecting to GPIO of E…
-
Investigate which encryption algorithm is best
suited for STM32F103C6T8, and (Arduino?), it
would be neat if it is easily portable.
-
### Is your feature request related to a problem? Please describe.
currently only in console log it is viewable with which signal strength the inverter is reachable.
### Describe the solution you'd …
-
Hi,
I'm not sure if this is the right place to ask, but I found this blogpost http://blog.ptsecurity.com/2016/06/phd-vi-how-they-stole-our-drone.html?showComment=1465942106913#c5816700951199608274 and…
-
## Edit Edit
Hi,
After doing some more research it seems like a lot of people have issues with the module nRF24L01+PA+LNA Antenna that im using. Ive seen on different forums that some claim that the…
-
The manual for programming the robot on Github lacks of some information.
So far I managed to get working the NRF24 sketches only.
the ledtest doesn't work.
the servo test moves with no sense when…
-
I've managed to get my CX-10 to bind via nrf24l01 only at one point. It connected for a few times after the initial binding then I put it away. Took it out the next day and was no longer able to get…
-
we need a Rc remote to manually drive the car when we are asked. Therefore the new car must be adapted to also be driven manually.