-
is there any way to modify sweep.c to make it in tx mode
is there a plan to do that or is this possible ?
because i have to hackrf and i want to make one of them a tracking generator and another on…
-
Current graph only allow for the x units to be in time units (s). Some instruments like spectrum analyzers, Vector network analyzers , frequency generators operate in Hz units . It would be very nice…
-
First of all, I would like to say thanks for such a great tool! I tried quite a number of other spectrum analyzers before finding Shiny and am quite happy with it.
I have a v3 RTL RDR with direct …
-
Hi,
I tried to get the modules running, but without success. How can I check if the wiring is correct? Maybe a small test-sketch which reads a known register? And How can I produce a signal I can see…
-
New audio features were announced for 3.2: https://godotengine.org/article/godot-32-will-get-new-audio-features
However, 3.1.1 RC1 was released and it seems like these features were backported to 3…
-
I am trying to get your software package STM32 IoT
SDK running on a board I developed myself. (STM32L071CZ + SX1276). The
software is running so far, but I cannot join into the TTN network.
The SX1…
-
The spectrum analyzer seems like a perfect place to have a parametric equalizer that could be applied to every stage of the signal. I think even four parametric bands would already give a lot of flexi…
-
Onboard receiver used to scan available channels and map out best frequency space for new racers to switch.
Automated switching to available spaces could also be a feature for users with a compatible …
-
```
After using a protocol analyzer to sniff the interface between the SPEkTRUM MCU
& the tx module, I suppose DSM2 header of Open9x is inaccurate.
Both X1TXN & X1TXO had been tested.
The first byt…
-
```
What steps will reproduce the problem?
1. Run Audio Spectrum Analyzer NOT in Debug Mode
2. Set Sampling rate to 96000HZ
3.
What is the expected output? What do you see instead?
Expected : To sho…