-
Hi!
I was wondering if someone can add support for Multiprotocol modules https://github.com/pascallanger/DIY-Multiprotocol-TX-Module
This is a module, based on nrf24 and if I remember well you can m…
-
Vorschlag:
Um die 3,3V-Schiene zu entlasten, könnte man im Mikrocontroller einige Peripherie deaktivieren.
Die Einsparungen müssten noch ermittelt werden (via Test oder eventuell gibt es bereits w…
-
Today I installed a diyBMS (esp32) setup in my boat. One controller and 8 battery modules. I already have two Juntek VAT-1050 shunts for measuring currents installed (one on all charge connections and…
-
Hi,
I was trying to get node-nrf to work right.
At first, I had to downgrade node to v0.10.16. After downgrading I was able to compile the needed spi libs.
My hardware is OK, because I'm able to …
-
Hi Goebish,
I tried to replicate using pro mini 3.3v + NRF24L01+PA+LNA (10uf capacitor 3.3&GND), i've used a 3.3v regulator to power both and it works fine, i have tested using a test transmit rece…
-
I've got some operations that are quite fragile to timing [multi-threading is not possible] and using `network.write` in between causes these operations to fail. I only want to write for sending agnos…
-
how to change the protocol for flysky i6...
need the ino file
-
we need a Rc remote to manually drive the car when we are asked. Therefore the new car must be adapted to also be driven manually.
-
-
Hello everyone (Hello Nathan... again).
I am trying make a litle test to see how nrf worls, butn I am finding any troubles. The (by the moment) principal issue is that when I try to send something th…