-
I want to connect 2 TMC2209 to arduino ,
when i send 1 in serial just one stepper worked wich have address 0b00 the otherone with ADD 0b11 not worked , however MS1 MS2 with Vio for Add 0b11
this…
-
Hi teemuatlut, you did a great job with this library!
I am having a little problem that I can't solve with your documentation (certainly because I am not much of a programmer)
I want to swap old A49…
-
I have problems with my BIGTREETECH SKR 2 board with a STM32 F429 chip on it.
I am using the current "Marlin-bugfix-2.0.9.2.x" branch from just now.
Performs builds for the BIGTREE_SKR_2_F429 enviro…
qulet updated
2 years ago
-
Hi,
can someone tell me the PWM Pins for the Partcollingfan?
FAN0 and FAN1 is used for hotendcooling.
So i choose FAN2 for the Partcooling, but they just start working @80% and this is full blas…
-
Hi I cannot seen to get the simple example to compile I get the following error
use of deleted function 'TMC2208Stepper::TMC2208Stepper(uint16_t, uint16_t, float)'
0; i--) {
digitalWrite(…
-
I have an example dual endstop for lowrider. I believe it is dual yz. But the Z endstops are a problem.
I think it would be best if the home dir was +1, and we set up the probe on Zmin. The two Z e…
-
Hello,
I tried several examples and different parameters on the examples provided, and none of them allowed me to reach the 1/3 of the motor speed.
At this time, I'm running the driver TMC5161 f…
-
Hi, i wrote a sketch using your library on an Arduino Nano while waiting for an ESP32 to arrive, but when i tried to upload that sketch to the ESP32, VSCode threw an error that your library only suppo…
-
Temmuatlut thanks for the hard work on this library.
I'm working with the 5160 BOB and while testing settings to evaluate what I want to use on my 3d printer I noticed some of the commands for 5160…
-
Hello folks.
I am trying to get the "MKS TMC2160-OC V1.0" driver working with my Arduino Uno board & a Nema23 stepper.
I connected all wires from the driver SPI (CS, DO, DI and SCK) to the corresp…