-
Rapidly looking at the code it seems that two very important features of the CC1101 chip are not used/disabled :
- Frequency Synthesizer auto calibration
- Frequency shift compensation
witch are…
-
I cannot compile on Arduino for Attiny85. Is there any issue? Is it supported? If not, will you add it?
-
please add irda and cc1101 on 443MHz
this will be a swiss knife for transmit, receive and data transfer modem. Meybe add 4-16 keys for send data directly from device
-
I am working on porting your arduino version to esp8266
I am having a few questions
- why not using the SPI.h arduino library for accessing the SPI?
Is there any HW issue I should be aware of?
…
-
Hi there, I have about 10 bracelets of EU model Cement 1.1 that I'm trying to test this library with (fresh batteries by the way). I'm using a Mega 2560 with no level shifter.
I'm having some small…
-
### Current Situation
1) Using ESP32 and CC1101
2) Building example OOK_Receiver. Set OOK_MODULATION to false
3) Can't receive proper FSK signal
4) Also, the pulse_data freq parameters are not dis…
habub updated
6 months ago
-
Bruce 1.3.1 running on m5cardputer via m5launcher.
when i select NTP adjust in clock menu, it crashes.
same behaviour on m5stickc plus2(flashed)
-
Currently we are using Johanson Tech. 0915BM15A0001E integrated balun and filter (Center freq 915MHz). The required center frequency is 790MHz.
-
BIG fan of this project!
However I have a T-Embed which is based on the same board but has a dial pad and one button. Would it be possible to port the firmware for the LilyGo T-Embed in the future?…
-
ERF R003 v2.0 CISECO CC1101
http://www.ebay.de/itm/ERF-0-1-034-pin-spaced-radio-module-by-Ciseco-/322008562140
Das Datenblatt zum C1101 gibt einen zusätzlichen Range Extender C1190 an.
Der erhöht …