-
**Describe the bug**
Intermittently, the aircraft, when powered on and sitting on the ground with no RC transmitter turned on, will print out that it lost RC control, arm itself, spin up the motors, t…
-
I connected the TX pin of Serial1 to the base of transistor and the SBUS RX pin of my flight controller to the collector. And I tried to send SBUS packets to the FC by using the example sketch, which …
-
**Describe the bug**
After successfully deployed `ROS2` and `px4_ros_com` on my board, I cannot open a specified serial port. My system always returns a error information when I operate the serial po…
-
I run Omnibus f7v2 on BF 4.1RC5 + Typhoon32 v2.2 (32.7fw).
- RPM telematics in CLI are received with motors spinning, but Voltage and Amps data is not showing up.
- After a few test motor spin up…
-
All kinds of glitches:
- sensor lost messages quite freqently on Taranis X9D+(even though I have no ESC telemetry enabled, no telemetry sensors like ESC, fuel, AccX/Y/Z, GPS set up
- some lua page…
-
I have receiver FrSky R9 Slim, flashed to the newest available EU/LBT firmware, also the module R9M si flashed to newest available EU/LBT firmware. The receiver is connected via dedicated S.BUS port (…
-
Hello Sergey,
I'm writing in English as the question could be potentially interesting for English speaking auditory, but, if you like, we can continue in Russian.
Yesterday I managed to feed th…
-
Good Day!
Please, correct me if I am wrong, but should that part of code:
void SBUS::write(uint16_t* channels)
.....
packet[1] = (uint8_t) ((channels[0] & 0x07FF));
packet[2] = (uint8_t…
-
## Current Behavior
Wing disarms in areas where RXLOSS is often accuring
## Steps to Reproduce
1. install 2.2
2. use below configuration
3. fly in area/distance where RXLOSS occurs
## Expect…
-
I have a TK1 connected to a modem that is handled by ModemManager and eventually pppd. The system usually operates as expected by booting, connecting to a network and remaining connected to a network …