-
**Describe the bug**
From time to time when I check on xtouch I see the printer selection prompt.
**To Reproduce**
N/A
Unfortunately, I'm unable to provide repro steps.
**Additional context*…
-
Reduced from https://github.com/tavianator/bfs/blob/main/tests/xtouch.c
```console
tavianator@tachyon $ cat foo.c
#include
#include
struct {
enum { a } b;
} c;
char d;
void e() {
…
-
When performing the OTA update the xtouch starts the download, gets to around 50% and then says verifying and fails. It does retries this 5 times then shuts off the OTA update. It appears that the v…
-
**Describe the bug**
The controller moves the Z-axis under the following conditions, even though I intend to move the Y-axis. After a Z-axis movement (only the upper and lower arrows appear on the di…
-
I use my xtouch not at my printer.
I would love to have the chamber Temperature also.
Maybe therr is a way for a stand alone esp with the temp sensor what transmitt data to my xtouch.
-
**Describe the bug**
Setup & Flashing worked fine as described in the readme.md.; Connection to Wifi worked, however, the devices earches for hours without finding my p1p.
**Expected behavior**
…
-
## Feature Description
Add an ability to offset the temperature sensor to calibrate it.
## Justification
The sensor I got from the link are offset by 2-3 degrees. I checked the temperature u…
-
## Feature Description
After bying a P1S, the first thing is to change the display. Second is installing a bright chamber light as the original Bambu Lab is more a toy than a light you like to have a…
-
## Feature Description
When I Load, Unload or Extrude filement using Xtouch there appear popups which says what I should do next. When you get used to your printer and Xtouch these popups are a bit…
-
For the first time, I had a failure to unload a filament via AMS after a print.
xTouch correctly showed me the message, but where it popped up the message on what to do, there's *supposed* to be a …