-
Would it be at all possible to re-engineer the ADS1115 plugin so that all four inputs are available from within a single task? As it is now you have to create a separate task for each input and for s…
-
Any idea why I get randomly 0 instead of the measured value? default SPS, single shot.
A0 and A1 are pulled to high (5V) and A1,A2 are pulled to GND with 1Mohm.
1second between measurements.
0: 6…
-
Greetings,
We have found out that in case we use two of the same modules on different addresses (by soldering the address bridge), for example, two buttons. The device lists two buttons connected, …
-
PS C:\Users\mark\Desktop\new spot\SpotMicroESP32-Leika-master\app> npm run dev -- --open
> spot_micro_controller@0.0.1 dev
> vite dev --open
2:53:05 AM [vite-plugin-svelte] WARNING: The followi…
-
Hi, I am developing a customized PCB that uses ESP32S3 SoC and communicate with an ADS1115 via I2C on PlatformIO. I happened to have the address of my ADS1115 set to 0x49 by connecting the ADDR pin to…
-
Can't seem to get it to finish creating the necessary nodes.
Running Lineage 18.1 as of yesterday. Samsung A5 (2017)
[*] ConfigFS seems to be mounted...
[*] ...and usb_gadget is available
[!] us…
-
I'm facing an issue in mounting usb formatted in ntfs. Kernel 4.13 in antergos with gnome.
-
### Describe the bug
Building for BCM2711 (Raspberry Pi 4). I get the following error although v3-utils is not enabled in make menuconfig:
./../../../build_dir/target-aarch64_cortex-a72_musl/v4l-uti…
-
Following is the list of files changed as detected on 2017.05.20
Please review the file changes and close the issue.
-
I was building this for my SteamDeck and noticed that during compiling, it was building things like drivers for Wifi Chipsets the Steamdeck doesn't have, as well as things like Nouveau.
Would it ma…