-
For reasons unknown to me I can no longer switch to DFU mode. The Levithan is installed in a working printer and no other USB devices are connected
Here is the dmesg output after pressing the boot …
-
Hi there, I'm much appreciate your work. In the future, can you consider to support stm32f1 series? I have a blue pill which is based on stm32f103 and I can't find dfu bootloader for stm32cube. Thanks…
-
Hello, I hope I'm not asking a question well documented in this project, because I failed to find any, I spent most the time digging the application part of this project.
So how does it work? Can s…
-
We need hex file support because android DFU library supports only Hex file.
-
**Hi!**
_Before we start, I want to clarify that I’m not using SDRAM and that I only want to activate a single effect._
I’m facing an issue with the SMD version of the pedal. Indeed, when I stri…
-
### Issue
The "_ux_device_class_dfu_entry" function does not support the "case UX_SLAVE_CLASS_COMMAND_UNINITIALIZE".
I think that it is necessary to support "case UX_SLAVE_CLASS_COMMAND_UNINITIALI…
-
After some time, I wanted to flash newer firmware (for #1678) on the primehub that was still at **this** CI firmware (build 3380 I think).
1. Bluetooth is enabled on the hub.
2. Press the bluetoot…
-
Hi,
I was looking through usb/usb_dfu_ctrl_ep.v to determin why I am not able to boot the application for the logicbone target.
In the following section:
```
// The DFU specification suggests …
-
Hi all
Tried to flash my board via DFU and followed the instructions of the manual.
All went quite well the way as shown in the manuel included the error warning that could be ignored
But my mc…
-
Hi, I seem to have bricked my TS100 using release 0.2. I'm not sure what's gone wrong since everything seemed to proceed as in the instructions. I first installed `runtime.hex` using stock mass storag…