-
Fanstel make a number of FCC-approved modules and dongles built on the Nordic nRF52840 system on chip.
There are a few differences in how the chip is wired up which makes stock OpenThread incompati…
-
Since nrf_to_nrf isn't a named lib dependency, the lib is not installed in CI and [fails on the Arduino 33 Nano BLE](https://github.com/nRF24/RF24Network/actions/runs/3826975905/jobs/6511195829#step:3…
-
At the moment the system clock source needs dedicated driver, which exports both tick interface (`z_clock_*()`) as well as cycle interface (`_timer_cycle_get_32()`). Any change in the area needs rewor…
-
I'm using an Argon on DeviceOS 5.0, and when I compile this library, I get the following error:
`lib/neopixel/src/neopixel.cpp:67:30: error: 'HAL_Pin_Map' was not declared in this scope; did you me…
-
Hi,
i am using mbed-studio to develop firmware for my custom board based on nrf52840 but i am not able to upload the binaries to my board using nrf52840 dk with daplink software.
As i can see, i…
-
I am trying to use this library with the new Arduino Nano 33 BLE board and am getting compilations issues. From some research it appears to not be compatible with the Nano 33 BLE's UART setup. The iss…
-
## Expected Behaviour
Running `./deploy.py --board=nrf52840_dongle_dfu --opensk --programmer nordicdfu` should successfully configure the device.
It looks like the nRF52840 dongle needs to be po…
-
We have some devices which has exactly same flash controller, the changes between device to device are:
1. Flash start addr
2. Flash size
3. Flash sector size
4. RAM Size
As a sample [MAX326…
-
- Background
Suppose we have 6 wireless inertial trackers, each tracker is composed of an arduino controller, an IMU sensor (like mpu9250), and a nrf24l01+ module. We put these sensors onto human bod…
-
Hi,
I'm playing with RIOT, and I'm experiencing strange behavior after flashing RIOT binary onto LAUNCHXL-CC1352R1.
After flashing hello-world example I can't connect via openocd (JTAG) with the…