-
If you start the radio and a warning appears (throttle/switch/failsafe) it can be dismissed by tapping the screen anywhere.
This seems a little unsafe as the screens are capacitive and respond to a…
-
# The issue tracker is not a support forum
The LinuxCNC issue tracker is to report bugs in the software.
If you have a question about how to use the software, use one of the other methods detailed…
-
### Describe the bug
I want to use a Servo to stabilize the roll axis for the Gopro on my 7". In order to improve the FOV in turns for reelsteady go.
I checked if that would work by flashing the…
-
I've got Buwizz v1 device recently and it has following strange behavior: If there is constant motor output (e.g. via simple toggle or just during testing of channel output), the output is stopped aft…
-
## Current Behavior
The NOXE F4 FC from Banggood has been updated to a new version labeled "V1". The "old" target NOX does not work on that new hardware version.
## Desired Behavior
Support new v…
-
# Bug Report
## One-Line Summary
On `release-7`, the Phaser board initialization routine reproducibly triggers a RTIO underflow in some, but not all, scenarios.
## Issue Details
##…
-
Hi,
here my current setup kept as simple as possible in order to verify servos and motor:
Inav 2.1.0;
Mini Talon aircraft
matek F405 wing fcb;
Futaba R7008SB receiver connected to the board via…
-
Hi, I have problem with servo outputs for flying wing.
I have orderedd F3 Omnibus clone with current sensing: https://www.banggood.com/30-5-30-5mm-Betaflight-Omnibus-STM32F3-F3-Pro-Flight-Controll…
-
I can easily recreate an internal error using AP_Button if setup to use PWM input but the PWM input is zero. This bug is new in 4.2 (I tested with 4.1.5 and it didn't occur).
PreArm: Internal erro…
-
We are in the process of getting the issues list down to 0, or as close we can.
For this we need a lot of people, with as much different machine setups as we can, that are willing to load the latest …