-
I have one query
why is there feed rate are mention in G-CODE though feed rate are already set via firmware.
means
when I am generating Gcode for pen plotter i have option to choose feed rate of m…
-
1. Download the Grbl source code (v0.9i).
```
╭─michael@corwin ~/Arduino/grbl ‹master›
╰─➤ git branch -v
* master d226555 Minor bug fixes.
```
1. Make sure you are using the most recent version o…
-
As far as I understood, the request for help was for decrypting a strange sequence of bytes.
I was interested in the data, at the moment I plunged into the development of NetToUART (ws and telnet and…
-
Recently I noticed that there is something iffy with the movement speeds on our cutter. Initially I noticed that there was a huge speed difference between 1% and 0.99%. Further investigation using a l…
-
Hello,
I just installed a GRBL 1.1 Board (https://www.aliexpress.com/item/4000163253874.html?spm=a2g0s.9042311.0.0.4e324c4dWp6Cb9)
but the spindle does not run (it works with the control board s…
-
Status is reading "Port Opened" & will not allow Gcode to run or jogging.to be done.
Need status to read IDLE etc.
Command line in GRBL control shows lines of Gcode as sent, although when file is ex…
-
I'm not quite sure whom to contact on this matter. As far I understand, in case a company uses modified GPLv3 code, but doesn't share the sources, only the copyright holder of the software can request…
-
[https://forum.protoneer.co.nz/viewtopic.php?f=22&t=7460&p=10919#p10919](https://forum.protoneer.co.nz/viewtopic.php?f=22&t=7460&p=10919#p10919)
https://forum.protoneer.co.nz/viewtopic.php?f=10&t=7…
-
These 2 Functions do not allow to insert a floating point number under 1.
With 15W Laser If i use 1 as "Check Size Power" or "Tool Test Power", the Laser burn the wood
Is it possible enable the us…
-
Hi,
If i upload the firmware via vscode, it makes something i unable to figure out. E.g i can not change $32 to 1.
It says it did, but on next start it is back to 0.
And issuing an M4 shows err…