-
I can see in the [release and maintanance](https://docs.ansible.com/ansible/latest/reference_appendices/release_and_maintenance.html#ansible-community-changelogs) Dokument that a Version smaller than …
-
Particularly the distinction between health states `Alive` and `Suspect` leads to tight-coupling and suboptimal behavior. In general, exposing only the distinctions between "Alive", "Dead" and "Unknow…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Version of Corteza
2022.9.5 + 2023.3.0-dev.2
### Current Behavior
When nesting a swimlane with con…
-
The favourites list does not differentiate the type of activity. Unless it is used in personalisation such as in smart (if so, it is not mentioned in the userguide), it makes the whole point of enteri…
-
I had an area that I wanted to mark as a paddling pool in the online id editor, however there currently is no suggested preset for this. It would be awkward to tag it as a swimming pool, because you c…
-
1) What baudrate do I have to use?
2) What is the RX pin in the swim connector, the "swim"or the "reset" pin?
Cheers
-
When trying to load the swimmer environment, I get a
```
ValueError: XML Error: Schema violation: unrecognized attribute: 'collision'
```
error when mujoco 3.1.1 is installed. Downgrading to `mujo…
-
Per section 3.1 of the [SWIM paper](http://www.cs.cornell.edu/projects/Quicksilver/public_pdfs/SWIM.pdf), step 1 of a protocol round is to send a `ping` message to one other member (M𝒾). If no `ack` r…
-
Unable to determine what causes this, but randomly I will be unable to swim upwards past the current block of water I am in. Persists even when the Elytra is removed, only resolved upon death.
-
Hi all, I have run DDPG with default hyperparameters in mujoco swimmer-v2 environment, but the reward converges to a very low value, only 4 or 5, so the swimmer cannot swim at all. I did not change th…