-
### Issue related to
Sunsynk / mbusd Home Assistant Add-On
### Describe the issue/bug
I think this has started occuring since the most recent commits on the 19th of June.
Trying to change …
cods4 updated
1 month ago
-
### Windows Build Number
Microsoft Windows [Version 10.0.22000.176]
### WSL Version
- [X] WSL 2
- [ ] WSL 1
### Kernel Version
5.10.43
### Distro Version
Ubuntu-20.04
### Othe…
-
```
What is the expected output? What do you see instead?
Cannot read cpu fan speed, I can control the speed with control 2
What version of the product are you using? On what operating system?
Open…
-
Hi, I have two plugs (ea_psu_plug, motion_master_plug). below test gets stuck.
ideally, 1st phase should turn ON the power supply and rest phase runs actual tests with motor.
- **scenario 1 :** p…
-
```
cpu fan (fan #1) is not reported at all (0 rpm) or it reports it only after i
run the A-tuning (fan-tastic) utility of Asrock M/B and even then it toggles
between 0rpm and ~1060rpm all the time …
-
```
cpu fan (fan #1) is not reported at all (0 rpm) or it reports it only after i
run the A-tuning (fan-tastic) utility of Asrock M/B and even then it toggles
between 0rpm and ~1060rpm all the time …
-
```
cpu fan (fan #1) is not reported at all (0 rpm) or it reports it only after i
run the A-tuning (fan-tastic) utility of Asrock M/B and even then it toggles
between 0rpm and ~1060rpm all the time …
-
For the BMS to charge lithium cells safely, software should developed to monitor and control charging current and voltage over time.
Requirements
- Charging of the battery cell should be controlled b…
-
Since the voltage is measured by resistor divider, it will be affected by the temperature drift of the resistor, and the heating effect of those 20Ω resistors is still very obvious. I decided to add a…
-
### Problem description
New IKEA inspelning power monitoring smart plug pairs fine and has all the entities in Hass. However power and voltage are reported divided by factor 10.
### Solution des…