-
Hello,
I upgraded from .12 to .15 ... now her write to use a configfile.
my /etc/knxd.conf:
KNXD_OPTS="-n 'knxd' -e 1.1.240 -E 1.1.240:10 -f 9 -D -T -S -c -t 0 -b tpuarts:/dev/ttyS1"
where I h…
-
Would be nice to have an `` tag to check if tool parameters are correctly mapped.
-
This is probably a big change regarding online play and Multiplayer in general.
As we might see balance changes made possible by a config at some point, which is also heck of alot of work, could it b…
-
sidebar width
sidebar side
starting timescale
starting staffsize
-
It is confusing... jspm 0.17 uses jspm.config.js and jspm.browser.js. The documentation in the readme references 'relative/path/from/baseUrl/to/config.js' and 'system.config.js'. Which file is it?
-
_slate_
```
# Config
config windowHintsFontSize 100
config nudgePercentOf screenSize
config resizePercentOf screenSize
config windowHintsTopLeftX (windowSizeX/2)-(windowHintsWidth/2)
config windowHin…
-
render.py
-
Using this module to capture and back up running configs on various HP/Aruba network switches. It runs fine under my account, but when I change over to using the service account that is running it as …
-
The following end print macro is my suggestion. It will not only move the toolhead to a safe position based on what was just printed, but it will also turn off all heaters and motors once it's moved.
…
-
*A patch is given in [this comment](#issuecomment-2340536374).*
---
Ahoj,
with GCC 14.x, build fails for me with `error: implicit declaration of function ‘usleep’; did you mean ‘sleep’? [-Wim…