-
When a new firmware is available for the gnss receiver, it could be helpful to update it from RTKBase.
Problem: Currently, there is no Gnu/linux tool to flash a F9P
-
################################
STARTING SERVICES
################################
Job for gpsd.service failed because the control process exited with error code.
See "systemctl status gpsd.servi…
-
With the latest firmware, a F9P can provide some spectrum informations. here inside U-center,
antenna disconnected
![image](https://user-images.githubusercontent.com/8255984/214419289-3ae49a3b-52ed…
-
I'm using 2 different f9p kits. The C099 evel kit and the new EVK eval kit. Both from ublox.
The C099 works flawless!
However the EVK throws the following error (with the exact same working config):…
-
Hello.
I have two ublox zed f9p (one for base and one for rover) and try to get both Beidou signals with a strsvr ubx-> rtcm3 conversion.
I use the messages 1005, 1007, 1077, 1087, 1097, 1127, 1230 …
-
Hi,
I have been unsuccessfully trying to figure out how to use the ROS node to enable the RTK compassing for the EVB2.1, using two antennas connected to the F9Ps.
I am using the `example_params.…
jkaob updated
4 months ago
-
Hi,
I followed the manual as located here: https://drotek.gitbook.io/rtk-f9p-positioning-solutions/how-to-get-started/zed-f9p-rtk-configuration
The firmware of the F9P is updatet, also there is …
-
Also holds for:
```yaml
uart1:
baudrate:
in:
out:
uart2:
baudrate:
in:
out:
gnss:
gps:
glonass:
beidou:
```
USB baudrate still works though.
Seems like the int…
-
Currently, there is a restriction to 4 fragments of RTCM data totaling to a maximum of 720 bytes. I am using the F9P with all constellations (GPS, Glonass, Galileo, Beidou, QZSS, SBAS) turned on. Even…
-
With qgis 3.34.10 and up-to-date Contour plugin, I asked for contours from gpkg layer that has a "3D Measured Point" geometry column and a fid, and nothing else. (These are observations from an RTK …