-
## Version of the moonraker integration
1.3.7
## Describe your setup
Klipper: v0.12.0-317-gb89d5523
Moonraker: v0.9.3-0-g71f9e677
Mainsail: v2.12.0
Raspberry Pi 4 Model B Rev 1…
-
Klipper issue?? seems flashing is an issue with anything other than _shutdown_value: 0.0_ set.
this is NOT good...you should default to (hot end at a minimum) fans left on full power when t…
-
In moonraker you can add entries to check for updates.
In this case you can add the following to moonraker.conf and it will track the git or an individual branch.
https://moonraker.readthedocs.i…
-
When manually configuring marlin with Make menuconfig in klipper, there is not option for STM32G0B0 chipset.
-
This is a minor issue I've discovered recently -
I'm unable to configure additional thermistor and sensor using it via `services.klipper.settings` because klipper expects `[thermistor ...]` section…
sorki updated
2 years ago
-
I saw that Eddy is now supported in mainline klipper so figured I'd update everything with the hopes of it resolving some of my z-offset issues.
After rebuilding and flashing klipper for all of my …
-
### What happened
I have a Prusa Mk3s with a SKR 1.4 turbo.
I'm trying to complete the initial setup but always get the same error, when I reach the "T0 TOOLBOARD PREPARATION" step:
Error
Tool…
-
Is anyone running the configuration with an CB2 and the M8P V2? Currently I'm trying to control the speed of the Pi Fan through Klipper.
Sadly according to the documentation of both boards the requ…
cin3m updated
3 months ago
-
Please evaluate if it is really necessary to use a fork of the Klipper core for the SV08. A superficial inspection of your changes lets me think that this printer could run perfectly well with a pure …
-
### Is there an existing issue for this feature request?
- [X] I have searched the existing issues
### Is your feature request related to a problem?
Z movements when retracting (z-hop) require the …