-
Hi,
I discovered a bug in the LIN Library of the FSP 5.4
The Idle state of the Uart TX is low, but should be hight. There are missing bits in the CCR2 Reg inside r_sci_b_lin.c
see picture for blue…
-
Mixup 1:
Add a few UART:1 and a few LIN decoders to a project. Store the configuration.
Some of the LIN decoders are converted to UART:1 decoders.
Mixup 2:
Add a few UART:1 and a few LIN decode…
-
Hi, I try to control a Bosch Wiper motor [http://www.bosch-motorsport.de/content/downloads/Raceparts/en-GB/50954635117964683.html#/Tabs=50966027/](url) without success, after some research I found thi…
-
Good afternoon. Would you like to add Flipper Zero CAN LIN module support to your program. But there is 1 moment in the model the CAN transceiver MCP2518FD is used. that is, it has support for CAN-FD …
-
Hello,
Is UDS on LIN supported? I tried sending UDS Default session and I see that Master Request is properly sent with ID = 60 (0x3C) but then I see Slave Response header sent with ID = 125 (0x7D) w…
-
To all slLIN users,
the project mainline/upstream is hard to be found which results in annoyance, redundant solving of the already solved issues and other time waste. If there should be chance for …
ppisa updated
3 years ago
-
Does anyone tried using Bus master for LIN control using PLIN-USB hardware from Peak?
Tool says "Listed Hardware interface is failed" so wondering if the drivers of this device are being integrated i…
-
Hi Fabian,
first of all, thanks for this project.
I tried to use it in my RV with Truma Combi 4, but it don´t work.
My Truma Hardware is:
C4.01.01 / 0050.00
H1.02.00 / 0300.02
I tried with …
elojn updated
6 months ago
-
Does this project support LIN interfaces on hardware like PEAK's PCAN-USB Pro FD (https://www.peak-system.com/PCAN-USB-Pro-FD.366.0.html?&L=1)?
-
# Hacking My Car's Climate Controls, Part 2: Building the Interceptor - Bitzero Blog
A walkthrough of the hardware I built to intercept and modify the LIN bus messages sent by my car's climate contro…