-
Hi Kris,
I have the ladybug + MPU-9250 / BME280.
I sold the 2 I2C pads and GND + VCC (no more)
-->Is it great?
I trried to run this script : https://github.com/kriswiner/Dragonfly/blob/maste…
-
Hello Mr Kris, i am working with MPU9250 with the new nrf52832 development board i am having an issue with the initialization of the MPU9250 function every time i compile and upload it to the board it…
-
-
Hello,
I am curious if this code could be modified to fit the MPU9250 sensor for use with the magnetometer (heading axis) sensor?
I am using a cookie cutter Arduino library for the MPU9250 but th…
-
Need to re-enable MPU9250 support while working on the enhanced IMU code.
-
Hey,
I tried doing the same as you. I can find the I2C address when scanning but can't get the I2C devices to initialize.
#include
#include
#include
#include "MPU9250.h"
// ---------…
-
Hi, I am trying to add MPU9250 support into your tracker code thinking "how hard can it be". Well it turns out very, either I am completely on the wrong track or my brain can't quite handle it. The MP…
-
Hello, Kriswiner.
I'm a graduate student who is studying for the master's degree in automotive engineering.
I want to use dual MPU9250.
I found your code from github.
But, I cannot use it due t…
-
@kriswiner
Quick question for you, as the datasheet is not clear, and I couldn't find obvious hints.
If I powercycle an MPU9250, will the offset/registers be set to "default"/uncalibrated value…
-
Hey Kris, how are you?
Where can I get reliable MPU-9250. I've been struggling with mine because and I think they are fake.
Thank you!