-
Good morning
congratulations for your work. I'm looking to make a PCB with your system. I'm not sure I understand where everything connects
for the output and accelerometer extension I put them …
-
ESP32S3 ESP-IDF stable version 4.4 has been released, most features are available, SD card is not supported.
ESP32S3 more powerful than the old ESP32 , built-in PSRAM and FLASH takes up less PCB spac…
-
1.Deap learning 기반 COF 이미지 검사시스템
- 학위 논문으로 연락처나 email이 안 남아 있음
2.YOLO 개선을 통한 PCB 불량 검출 시스템 설계 및 구현
- lynnshin.tistory.com/47 // YOLO는 객체 위치와 클래스를 감지하는 모델이라 적합하지 않음
- 오히려 Resnet, DenseNet이 효율적인 이미…
-
# Motivation/Description ⛰️
The previous ADCS PCB was already getting full, and we plan on adding a lot more components to ADCS this year. There is space allocated for 2 PCBs for ADCS, so we should …
-
Now there is only a schematic diagram, no PCB number diagram, and no corresponding device number on the motherboard is known.
-
I have studied your page and made a custom pcb using the MX26L6420 memory using your available diagram, and the software for the programmer, but there was a doubt related to homebrews larger than 64Mb…
-
I ordered a small run of your Cing ultrasonic printed circuit boards from:
https://www.pcbway.com/project/shareproject/I2C_Ultrasonic_sensor_with_compensation.html
The silkscreen shows parts place…
-
Between the spacer dimensions in `Mechanical/Small/Module/c1_design_space_ref.pdf` and the PCB limit area dimensions in `Mechanical/Small/PCB/c1_pcb_concept_design_ref.pdf` there appears to be an "off…
-
Hi All,
As shown below, Enable (Pin 11) is Positive and has a Negative Common (Pin 7).
The diagram for the ELS PCB shows a Positive Common.
Will it be possible to use Enable with this drive?
T…
-
I am unable to see ESP32 in the wiring diagram of the DIY bot.
Can do steps mentioned in the ESP32 be implemented circuit digram send it or any diy esp32 pcb circuit