-
Hi everyone, i`m using a Pointgrey Blackfly Camera (BFLY-PGE-23S6C, 1920x1200) through ROS pointgrey_camera_driver.
My camera works perfectly on FlyCap2, where i can easly reach 40Hz of framerate (th…
-
I am using Ubuntu 14.04 and ROS indigo to run two pointgrey GigE blackfly cameras.
Now the problems is every time after I power on the cameras and run the "camera.launch" file, I always get the follow…
-
1) Ubuntu 16.04 LTS AMD64 with i7 4 core
2) ROS Kinetic Version
3) pointgrey_camera_driver git clone from source code
4) cameras connected with GPIO cables
5) use FlyCap2 GUI tools to setup "Hardw…
-
Hello,
I have not been able to launch the driver to work with my Blackfly camera. (I am running ubuntu 16.04 and ros kinetic on my computer).
I can run list_cameras with no issues:
Number of camera…
-
Is there a particular setting to set the trigger based on software?
I have gone through the cfg file provided with the ROS package. But I am not sure which setting is for the software delay or if …
-
Point Grey is releasing their new models using the Spinnaker with GenICam3 support rather than flycapture2. Any thoughts on supporting the new sdk?
-
We previously updated to 2.7.3.13 and then reverted to 2.6.3.4 due to #28. It would be great if someone could take on checking what the story is with 2.8.x and multiple cameras (as well as checking fo…
-
Hello!
I am installing pointgrey_camera_driver how writing in http://wiki.ros.org/pointgrey_camera_driver.
This two commands running succesful:
sudo apt-get install ros-indigo-pointgrey-camera-driver…
-
Hello,
I am using two backfly cameras to obtain a stereo vision. After I succesfully launch pointgrey camera ros driver in stereo mode, I am able to view images on rqt_image_view. However, I cannot …
-
I was unable to build `autorally` on Melodic / Ubuntu 18.04 via `catkin_make` due to the following linker error when building the `autorally_core` package.
```
[ 92%] Linking CXX executable /ros_w…