-
The IDE 2.0 fails to compile any code for OpenCM 9.04, even a "blank" code:
```
void setup() {
// put your setup code here, to run once:
}
void loop() {
// put your main code here, to ru…
-
When I compile code on Arduino, it shows me 'Dynamixel' does not name a type. What libraries should I import? Thanks!
 and OpenCM9.04 via Bluetooth module BT-410. Could you help me how I can carry out this communication?
-
Hello everyone,
I'm starting to code a code with Dynamixel2Arduino library to control multiple xl430 and x320 (2x xl430 2x x320).
I use : position_mode to control my dynamixels, it works fine with …
-
Hi, I am trying to set up OpenCM904 with Serial1 (TX connected to USB-RS232 dongle to access it through COM port on "Flash Loader Demonstrator" from ST Microelectronics, since it has STM32F103CB MCU. …
-
Hi,
I have a XH430-W350-T. I am trying to communicate with this servo using MATLAB Simulink through the Raspberry Pi on TxRx GPIO pins.
I have built the half-duplex level shift circuit suggested b…
-
This has been mentioned in a few different threads on Robotis forum, such as: http://en.robotis.com/service/forum_view.php?bbs_no=2406740&slg=&page_type=&mode=&submode=
I have an OpenCM9.04B board …
KurtE updated
4 years ago
-
Hello! My question is: is it possible to program this board barebones? For example, if I want to start my OS on it?
Le0nX updated
4 years ago
-
BE CAREFUL!! FOLLOW THE RULES AS FOLLOWS, OR YOUR ISSUE WILL BE `WON'T FIX` ANYWAY
I'm using `DynamixelSDK ver. 3.7.21
- I'm using `Arduino IDE` Language
- I'm using `OpenCM904 + Open CM EXP` …