-
Hi, and thanks for your work!
I would like to see some SDCC examples using this. I'm currently migrating a project from IAR to SDCC and it's becoming quite difficult to manage the differences without…
cocus updated
3 years ago
-
Is it possible to both flash the esp8266 of the ESP-14 and also flash the bootloader to the STM8S003. The Module has ESP_GPIO0 pin and RX/TX pins on the STM8S, that are also connected with the esp8266…
-
Im getting this (first time):
`*** USB Error: [Errno 32] Pipe error ***`
and then this (every next time)
`*** USB Error: [Errno 110] Operation timed out ***`
I really don't know where to start
-
The library is just super!!! I try to compile the project under STM8S103F3P6 and get errors. Please help to adapt for this controller. The controller is very cheap and therefore very suitable for sens…
-
Continued from issue #2
When I investigate further.
I found that the code is misleading.
[Here the issue](/vdudouyt/sdcc-examples-stm8/blob/4239cb/uart.c#L16)
```
CLK_DIVR = 0x00; // Set the freque…
-
Hello
im interest in building DDOZER really loved the design. the question is can i change the STM8S105K4T6C with the prebuild stm8s? (not the IC version but the prebuild like arduino nano version) s…
-
Error: 13 INTERNAL: Cannot install platform: installing platform sduino:stm8@0.5-pre2: searching package root dir: no unique root dir in archive, found 'C:\Users\Akash\AppData\Local\Arduino15\tmp\pack…
-
Hi @tenbaht ,
I am new to this environment. I am trying to do get IR signal and measure timings of IR signal. For that i want to use timer and external interrupt. I am writing code in Arduino I…
-
Hi ,
I am trying to read a remote using TSOP receiver with rc5 and Nec 5 protocol.
I am using STM8S003K3 controller.
I want to operate my device with button and remote.
Can any one provide the…
-
```
Implement MCU and system low power modes which can be enabled through system
calibration data.
```
Original issue reported on code.google.com by `ileacris...@gmail.com` on 5 Sep 2013 at 12:07