-
Hi all!
I have the following setup in my laser cutter/engraver project:
- MKS DLC 32 v2.1
- TMC 2209 Driver
- 3 Nema 17 stepper motors
I have tried various configurations without success; t…
-
### Wiki Search Terms
UART; Homing
### Controller Board
Single esp32 with 2 tmc2209
### Machine Description
Simple machine with two axis controlled by a TMC2209
### Input Circuits
…
-
Hi, Im trying to configure the board and change the driver current, but i tried setting monitor driver status, but i get this message:
18:58:52.344 : E (5870) uart: uart_get_buffered_data_len(1342…
-
Hello,
I have SKR3 EZ board with old TMC2209 drivers that should be compatible. However, I am getting:
```
Driver registers: …
-
I enable TMC_DEBUG and got this:
[2021-06-26 15:58:21] connection...
[2021-06-26 15:58:21] M1:LOW
[2021-06-26 15:58:21] M2:LOW
[2021-06-26 15:58:21] M3:LOW
[2021-06-26 15:58:22] TMC ERROR
It l…
-
At the start i must say i'm total new with arduino ide, so i might be doing something wrong, however i'm trying to use 3d printer board for other purpose, but by all means i can't get it working.
The…
-
I was going through the code and read somewhere (in my_machine.h) that it is work in progress. Also generic_map.h, i see that if TRINAMIC_ENABLE is present then error will be generated.
#if TRINAMI…
-
I have TMC2209 on uart mode for x & y drive. Do I need 3,3V or 5V on drive ic- pwr jumper to use sensorless homing? I'm using klipper.
-
I have several TMC 2209 V1.3 drivers and I want to connect them via UART via hardwire. TMCs come with 3 pins marked RX, TX, and CLK. Using the RX or TX pins with and without a 1K resistor I am not abl…
-
I'm a newbie with grblHAL, so apologies if I missed something in the documentation I should've seen.
I set up a new environment for the SKR 2 with TMC2209s as follows:
```
[env:btt_skr_2_tmc2209]…