-
**Folder/Page:**
Need to fill out the section on the main power harness in [wiring assembly page](https://github.com/RespiraWorks/Ventilator/tree/master/manufacturing/electrical/wiring)
DIN female…
-
Hello, thanks for the reverse engineering work!
Where in the wiring harness should we tap into to access this data? And once you make the connection, is the data immediately available, or does an …
-
In Unit A-7, 7.1, Prep IR Sensor Wire and ADC, picture shows and asks to cut the black connector. Wiring harness supplied does not have that and is in fact already tinned on the stripped end.
-
Current wiring diagram for Duet 2 doesn't match what the current motor kit actually comes with. The out-of-the-box order of the wires on the premade harnesses work correctly, update the diagram to mat…
-
In its current state, the wiring between various parts of the rocket leaves much to be desired. Cables snake around the rocket and it is difficult to integrate everything before launch. As such, bette…
-
Some variants of Equinox use pin 12 instead of 11 for the SWGMLAN.
-
The readme.md is very well written and provides virtually all the information that is required to use the various interfaces, it is a sign of the high level of professionalism of this project, where m…
-
When I connect the servo wires to the rpi with the 22K ohm resistor wiring harness, the intput of the signal wire goes up to 5 volts as well. That is okay for an Arduino but the RPI has a 3.3 volt in…
-
Hi, the word "pin" implies a male contact connector.
"Pin" is used commonly for through-hole PCB parts, as these will always be male gender, but is less relevant to connectors for wiring harnesses…
-
The instructions for the wiring harness are very minimal.
## High Beam
There are three wires that go to the high beam switch, and some that go to what they call the high beam terminal. We nee…