-
The PCBs have non populated space for a diode, terminal block and 5v relay (not sure which type fits but it's a six pin model). I wonder if this is supported by the original firmware and what it does.…
ghost updated
6 years ago
-
V. 2.7.92 . SDR mcHF v.04 . Mem. 512. DSP A-NOTCH not working perfectly. Fully distorts the signal and makes a noise like a steam locomotive.
http://www.qrz.lt/ly2bok/Laikinas/A%20Noch.mp3
LY2BOK …
-
Hi,
I have a little problem with the Libraries v.3.0.0 and before on my Arduino Nanos (IDE 1.6.11). ;-)
E.g. "Simple_Clock" will not synchronize; so I see "Initializing..." and a lot of '.' only.
B…
-
The current code works properly for AVR based Arduinos because digitalWrite will enable the pullup. This once used to be the proper way but nowadays pinMode can be used to enable the pullups. This is …
-
Hello,
I would like to thank you for your work on DCF77 libraries. They work brilliantly! I have replaced resonator on my Arduino Uno board with an oscillator, tweaked yours examples and it is working…
-
Hi, In my dcf77 alarm clock scetch I use the following code:
void sound_Alarm() {
tone(ALARM, 2000);
delay(50);
noTone(ALARM);
if (digitalRead(panic_Pin)) alarm = LOW;
delay…
-
Joachim Grimm reported, that void adjust(...) fails to recompute the weekday. The issue affects the examples simple_clock_with_timezone_support as well as the swiss_army_debug_helper.
-
Results at first: Udos DCF77-library works as expected. If not, have a look on your hardware.
Hello Udo, you remember that I have a little trouble working with your DCF77-library (based on your 'Si…
-
The Issue was reported by Uli Fuchs here: http://blog.blinkenlight.net/experiments/dcf77/super-filter/#comment-52182
-
_Simple_Clock_
```
Simple_Clock.ino: In function 'void setup()':
Simple_Clock.ino:59:21: error: 'Clock' is not a namespace-name
Simple_Clock.ino:59:26: error: expected namespace-name before ';' token…