-
### Describe the bug
I noticed that the CVL reset also happens at SOC_LEVEL_TO_RESET_VOLTAGE_LIMIT
even if linear mode is enabled.
I have a SOC drift of the JK BMS in summer so I selected the M…
-
### Describe the bug
The MPPT´s show 0.4V higher charge voltage than set in the app, the settings of serial battery or elsewhere. Why is that?
![IMG_3074](https://github.com/Louisvdw/dbus-se…
-
### Describe the bug
I got a new Daly BMS with FW 11_230627_001T and here the data is not available in MQTT.
In the old Daly BMS with FW 11_220722_100T all works OK.
Both Daly BMS show data in …
-
### Describe the bug
If I turn on Linear Limitation and CVCM I see MAX_CELL_VOLTAGE 55.36 but in config.ini it is set to 55.2 (3.450)
### How to reproduce
### Expected behavior
Keep MAX_…
-
### Describe the problem
See the attached log screenshot:
![grafik](https://user-images.githubusercontent.com/125830597/236640102-3b48cdfd-00eb-4f83-9b5a-0531f0a1006a.png)
### Driver version
…
-
Two Würth WP-BUCF power connectors are planned for Bat+ and Pack+ each. The possible issues with this are
- majorly the increase in cost for 2x of these costly connectors
- Lugs are designed in su…
-
### Describe the problem
I have got a 3 phase Multiplus 2 5000 and a 2 batterie 18S system.
As soon as the set voltage is reached and DC feed in is active, the power constantly fluctuates betwee…
-
### Describe the problem
Hello,
I can not change the DCL value on version V1.0.0.
I got a "Permission denied" message.
I don't understand.
Can you help me?
Thank you so much
### Driver vers…
-
As a newbie, I would like to ask how to use only 1 arduino to read the battery voltage and the charging state status of the SRNE? How will I connect it to arduino? Thank you very much for your help.
-
### Describe the bug
The new SOC calculation leads to different SOC values shown in the Xiaoxiang app (via bluetooth on iOS) and in dbus-serialbattery.
https://github.com/Louisvdw/dbus-serialbatter…