-
Hello,
I try to run your driver on ROS and do have some problems (I'm new to Ubuntu and also have no experience with ROS).
I use the thermal camera FLIR A65, Ubuntu 14.04 and ROS Jade Turtle.
Clonin…
-
I don't know if you recall, but a few months ago I mentioned that I am working on an open source protocol and I wrote the code for Multiprotocol to be the transmit module. I have finished up the rece…
-
Add support for native FrSky telemetry (S.Port based X-Series receiver) using only a simple external inverter (i.e. https://github.com/TauLabs/TauLabs/wiki/User-Guide:-FrSKY-S.PORT-telemetry).
Somebod…
-
If someone is flying with a joystick or GCS's virtual sticks, it would be good to allow the pilot to forcibly retake control from the GCS by flicking a switch (flight mode? ch7/ch8?) on the TX. It's…
-
CF failsafe is configured to go into CF stage 1 when the receiver stops sending valid pulses (the receiver is no longer connected to the FC).
This is fine for cPPM.
The CF FS is also set to go int…
jj-uk updated
7 years ago
-
Had an interesting behaviour on a X7 from a friend. Seems that Crossfire telemetry generate constant report telemetry lost/regained.
X7 running RC18 (no-heli, lua, diy module)
The behavior is si…
-
SBUS has a bit to indicate failsafe condition (no need to special failsafe channel values etc).
iNav seems to detect this flag, for example:
- it sets throttle to minimum in the receiver menu, and …
-
Hi there
I wanted to test the MSP over SPORT function with my OmnibusF4 FC to configure PID settings with my Taranis. But no values will be displayed. Telemetry seems to be ok, cause I get voltage,…
-
Enabling serial comms on current version 1.13 allows some data to be read over serial (specifically attitude and current rx settings), but does not support writing writing rx values (for example setti…
-
Hi there,
I understand that according to [this mbed post](https://developer.mbed.org/users/Digixx/notebook/futaba-s-bus-controlled-by-mbed/), the stop byte at the end of every packet is supposed to…