-
hello:
Several Brushless chips can be driven by PWM signal, but need to have the registers configured by spi....
i wonder if it would be possible to have an SPI interface and I/O pins . ?
Cheers !!!…
-
Hi, this is my setup
BTT SKR 3.0 EZ H723 with 4 motors connected on TMC5160
With default mode 1 motor per axis XYZ it works.
When enabled, Y_GANGED/AUTOSQUARE, Y motor on Y driver does not work…
-
We are developing a bio-printer that uses a syringe [1] instead of continuous feedstock on the extrusion axis. Because of this, it will be necessary to add an endstop to the E axis and to have limits …
-
Hi all,
I'm really struggling to get the steppers(23HD86001Y-21B) setup properly.
They 'groan' and like bind if i jog more than 10mm. i copied the settings from my fluidnc config which works fin…
-
I focused several issues and actually trying to figure them out.
My system:
All steppers drivers are TMC2130 (SPI)
2 Z-Axis
SDCARD Support
Now I´m focusing the following Issues:
When setti…
-
I have encountered a problem, I use the latest marlin firmware and 5160 is OK on my motherboard. The configuration is not changed, only the drive is changed to 5161, and the information displayed usin…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Hello, dear Marlin community
I´ve discovered a strange behavior when I was trying to impro…
-
In certain configuration parameters, Klipper assumes default values if the field is omitted by the user or not explicitly specified. This has led to some ... concerning user error scenarios in practic…
-
I'm proposing a "speed blacklist", 1 range (i.e. 50-60mm/s). When set, the slicer would either speed those moves in that range up or down to avoid the resonant frequency of the printer. This is would …
-
This is an already known issue, but posting here for tracking purposes.
The J1 encounters an unexpectedly high number of failed prints due to layer shift issues.
I have attempted to print large…