-
### Should be:
According to specification, S.Bus output should be **SERIAL_8E2**.
## Is:
In OpenTX 2.2.1, Taranis X9D+, S.Bus output in transmitter bay on PPM pin is **SERIAL_8N2**.
-
Matek Systems F722-STD
1.9.1, 2.0.0 rc4
INAV/MATEKF722 2.0.0 Jul 14 2018 / 22:39:19 (f2cf315ad)
### Behavior
Cannot connect configurator to matek fc without connected battery. After I connect …
-
Can't get the magnetometer to be recognized on omnibus f4 v3. Frsky sbus on uart 6 (sbus, 5v,gnd) and gps on uart 1 are working. Mag to scl and sda will not for me. Any ideas
-
Is it possible to make a feuture that we will connect the osd cable from our camera to a uart port, and change the settings of the camera using Taranis or betaflight osd, without having to take apart …
-
Add support for native FrSky telemetry (S.Port based X-Series receiver) using only a simple external inverter (i.e. https://github.com/TauLabs/TauLabs/wiki/User-Guide:-FrSKY-S.PORT-telemetry).
Somebod…
-
Expanding on the DSM2/DSMX serial protocol that is already available but limited to 6 channels, I'd like to see some serial protocols available on the PPM output pin in the module bay. Specifically SU…
-
Hey everyone,
First board with betaflight. first time posting in this repo.
First things first, I'm using a Flip32 Omnibus V3, this one:
[http://cdna3.zoeysite.com/Adzpo594RQGDpLcjBynL1z/cache=ex…
-
I don't know if you recall, but a few months ago I mentioned that I am working on an open source protocol and I wrote the code for Multiprotocol to be the transmit module. I have finished up the rece…
-
I have been working on getting smartport working on F4 targets.
Because the F4 does not natively support UART inverting, I used the taulabs inverting circuit on UART3 in an attempt to get some sor…
-
First of all, thanks for the code!
1.) Which output pin on the Arduino does the SBUS signal come from?
2.) I saw mention elsewhere of the need for an inverter. It's not mentioned in the notes so do …