-
So I did not see any information on this anywhere in my numerous google searches. I have a melzi 2.0 board that I had recently replaced. I have everything reconfigured from my previous settings but I …
-
I am using a custom Delta printer.
I was working OK with RC7. Today tried RCBugFix and can't get auto bed leveling working right.
Goas down to bed at negative X until tohchs the bed.Then moves right…
-
When I try to enable the use of my VIKI 2 LCD I get a compiler error in ultralcd.cpp at line 2695
'u8g' was not declared in this scope
I've checked my configuration.h file and I think I have everyth…
-
Large kickstarter dataset is most restrictive so will match all other dfs to that.
-
I continue to have problems with the auto level, after many tests I realized that does not seem to consider or is treated incorrectly, the test point near X: 0 Y: 0.
The defect which I note is that t…
-
I opened two tickets for the auto level problem of my printer. I tried different branch but with all I have always the same problem.
The last code on my printer is Marlin-RCBugFix of 21/09/2016.
On my…
-
I just upgraded my Prusa I3 to RC8 and got problem with G29. I also tried RC8 BugFix but same problem. I can do 28 homing and it´s working good but when i start the leveling with G29 it goes to the fi…
-
Trying to use the standard Marlin 1.1 package on a RUMBA board ( Board 80) I recognized the following!
using X;Y;Z and E0+E1 works fine, but additionally using E2 causes missbehaviour
I built a Gcod…
-
Hey guys, I was directed here by the users on the Robo forums. I am trying to setup my LCD and all is well until it gets to the LED color portion. I get a compile error stating a line in the code is n…
-
I use ramps 1.4 arduino mega shield with arduino mega and the full graphics discound smart controller. I uploaded to the controller the bugfix 1.1.x but the encoder still not working. when i push th…