-
I cannot figure out which pins to set for the reset script.
spi and i2c are enabled.
tyro@rpiz:~/LR1302_loraWAN/LR1302_HAL/sx1302_hal/packet_forwarder $ ./reset_lgw.sh start
CoreCell reset thro…
-
### Describe the feature
By default autoclicker can only click predestined position when using image detect mode
But there are many scenarios that a offset is required to click correct position
…
-
Under this full release (and test release) FX-RCR will connect to computer and logging software under TS-590S. However, frequency is NOT displayed on computer software even after changing frequency on…
-
I read on the forums and from the documentation that the nRF5 series are supported to some extent. I am wondering what does it actually take to get the gateway sketch running on the device?
Right …
-
Hello all,
That request is all about the transponder data.
1) Have the ability to manually update or edit transponder data of satellites
2) Have the ability to set mode (FM/SSB/CW) for each u…
-
```
No radio input in HIL mode causes APM to not work. It works Ok with radio PWM
input but as soon as the PWM input disappears the autopilot stops navigating
and behaves oddly. PC joystick mode is …
-
```
No radio input in HIL mode causes APM to not work. It works Ok with radio PWM
input but as soon as the PWM input disappears the autopilot stops navigating
and behaves oddly. PC joystick mode is …
-
```
No radio input in HIL mode causes APM to not work. It works Ok with radio PWM
input but as soon as the PWM input disappears the autopilot stops navigating
and behaves oddly. PC joystick mode is …
-
```
No radio input in HIL mode causes APM to not work. It works Ok with radio PWM
input but as soon as the PWM input disappears the autopilot stops navigating
and behaves oddly. PC joystick mode is …
-
```
No radio input in HIL mode causes APM to not work. It works Ok with radio PWM
input but as soon as the PWM input disappears the autopilot stops navigating
and behaves oddly. PC joystick mode is …