-
### Operating System
Linux
### Source of bug?
- [x] Original M.A.X. v1.04
- [ ] M.A.X. Port
### M.A.X. Port Version
Latest git
### M.A.X. and DOS or DOSBox Versions
_No response_
### What is t…
-
in a 1 vs 3, even if 2 target me (because cardinal point make 1 no interrest) , I can easyly prevent :
Starport allow Siege tank at early game.
orni attaks first target (so if you buy 2 orni each st…
-
* With 2 indexes, MN performance seems to plateau out at 1.6M rows/sec. Investigate via flame graphs on this
* With RF = 2, performance dips down to 50% of with RF = 1. Investigate via flame graphs o…
-
- [ ] Modded Lanterns
- [ ] Sea Pickles/Candles
- [ ] End Rods
- [ ] Flower Pots
- [ ] Modded Flower Pots
- [ ] Modded Layers
- [ ] Layers under slabs
-
-
`Minecraft v1.15.2`
`Forge v31.2.31`
`Double Slabs v2.9.0`
`Optifine vHD U G1 pre30`
I created a resource pack that makes use of optifine's overlay textures, but when a double slab is created, a…
-
expt-group-by contains a hyper_group_by which applies a "nominal-2D" grid coordinate point in polygon approach to the "polygon overlay" task.
http://rpubs.com/cyclemumner/284383
It's a bit slow…
-
I think we should drop support for QUIP and PEXSI because for all I can tell they are not really being used.
While in the past the maintenance effort was rather low, we would now have to invest qu…
-
Thanks for this great tool! When trying to burn the firmware to an Adafruit Feather board, I was running into continuous problems. It turned out that some USB chips require a slower baud rate, like 11…
-
Running All the Mods 5
Running Latest version of forge 31.2.9
DynMap 3.0.1
Latest Snapshot of DynmapBlockScan
I see the console freeze after producing the following output:
> [15Jun2020 21:1…