-
Wurde gewünscht.
Sollte ja mit dem nächsten Update kommen
-
Anycubic MEAGA X
MEGA_X_DGUS_v1.4.4.hex
Drucker habe ich von der Originalen auf die Marlin 1.4.4 geflasht
Jetzt macht er beim Aufheizen und Drucken sporadisch Klickgeräusche und der Drucker schalt…
-
Have a Z8T that I upgraded to use zm3e4 (v 1.0) board, the Zonestar wifi module (from Zonestar _official store on AliExpress,) 2208 steppers for all motors, and LCDDWIN (from same store) and using fir…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
In Conditionals_post.h
`#if HAS_TEMPERATURE && EITHER(HAS_MARLINUI_MENU, HAS_DWIN_E3V2)
#…
-
Hello I have the klipper firmware on my cr10spro v2 and it worked great, but now when I try to use the filament sensor mid print it is just crashing the klipper right away.
But that only happen after…
-
Currently the python application needed to be started manually, this is pretty unusable for productive usage.
A systemd service file that allows automatic starting and stopping of the display appli…
-
### Bug Description
Hallo, bei der FW v1.4.3 zeigt mein Mega X (erste Generation mit DWIN/DGUS II Display) nach dem Startvorgang nur noch das Anycubic Logo an und reagiert auf keine Eingaben über den…
-
Upload file from web (ESP3D)
Expected behavior: file uploaded on the SD
Actual behavior: it's not possible to load files with extension .gco if I use .gco it's not visible on display of the printe…
-
**Describe the bug**
Cannot set hotend past 100 for PID tune
**To Reproduce**
Steps to reproduce the behavior:
1. Go to PID screen
2. Click on temp
3. try to enter anything over 100
4. goes b…
-
### Bug Description
When adding the physical hardware of neopixels and ensuring the hardware works, I tried to fill out the neopixel code in configuration.h and then I built the firmware in pla…