-
***Enhancement Request, not a bug**
Currently, to change the Pump RPMs through poolController, you have to define circuits in your automation and then use poolController to turn on/off those circui…
-
Tag,
Here are the files from the capture.
[replay.zip](https://github.com/tagyoureit/nodejs-poolController/files/2891549/replay.zip)
-
Hi, I have a Zodiac Tri Chlor unit that has the ability to interface with a controller.
Is it possible to setup and run this software connected to the controller connection of the chlorinator to g…
-
As the title says, I'm a noob with Raspberry Pi and json. I initially hit some snags that I posted here (https://www.raspberrypi.org/forums/viewtopic.php?f=91&t=232293), but I think I was able to get …
-
### Expected behavior and actual behavior
Intellichlor is controlled by Intellitouch Load Center Panel. Chlorinator is plugged into the panel and showing a good status. Panel is correctly reading s…
-
Having problems writing to serial bus. I have a Waveshare HAT RS485. I have a Pentair Easy Touch Controller with a heat pump and Intellibright light.
> nodejs-poolcontroller@5.1.0 start /Pubs/nod…
-
# 🐛 bug report
Hopefully this is just a setup issue, but I don't know where to start. I looked at a lot of other issues but didn't see anything relevant.
In short, with Dev environment:
* Work…
-
### Expected behavior and actual behavior
Opening the web UI expect to see the pump values but are just populated with "wattsnotset", "rpmnotset" and the same for all the others.
### What is actua…
-
and another controller (intellitouch/intellicom) is present.
Does this mean the software cant run when this runs?
-
### Expected behavior and actual behavior
When logIntellibrite is on, I'm getting the following error:
Unhandled rejection TypeError: Cannot set property 'light' of undefined
and thereafter e…