-
this is the dump i tried when i flashed. dont remember exactly which version i came from. but only motor 1 spins when armed. flashed back to rc4 and all 4 motors worked again. i noted that while on th…
-
I have a fleet of quads with the same components. Yesterday I built a fresh one and flashed RC4. I run 5050C Dal Biblades exclusively on this fleet but when I went to fly/tune the quad was unfliable a…
-
(Similar issue as another issue that was closed a while back, but none of their "fixes" fixed mine. CPU load is steadily around 15%.)
I'm using a ImpulseRc Helix and am not able to get it to arm. The…
-
Hey Guys,
I just flashed my BFF3 with the 3.2 firmware and for some reason only 1 motor spun up. After a while it also stopped spinning. Using the beeper sometimes made my 1 motor spin up and ano…
-
I'm using the new FRSKY XSRF3P0 board, with firmware version
# Betaflight / FRSKYF3X 3.2.0 Jul 14 2017 / 11:40:09 (a5f7fecc5)
I've noticed today that when using betaflight configurator today the g…
-
Working with Eachine Racer 250 (naze32 board).
When I use betaflight I am not able to arm it. It arms fine with the latest cleanflight.
Here is dump, status and tasks outputs..
Entering CLI Mode, t…
ggg22 updated
7 years ago
-
In Betaflight It can Auto detected and read fine. But in Inav its not auto detected.
Also, when I set manually `set baro_hardware = MS5611` the CPU load rise to about 660%
![screenshot from 2017-04-…
-
(Similar issue as another issue that was closed a while back, but none of their "fixes" fixed mine. CPU load is steadily around 15%.)
I'm using a ImpulseRc Helix and am not able to get it to arm. The…
-
Hello,
I just recently changed my Video Transmitter to a TBS Unify Pro V2 (5V Input), and have wired the Smart Audio into UART3's TX pin, and afterwards my LED's stopped working, and when using the…
-
Hi !
I'm having an issue getting any SD cards to be initialized by Betaflight using the SD card slot on the AnyFC-F7
The card is formated with FAT32 , is class 10 and with 8GB
When in the blac…