-
First of all, thanks for this awesome library!
I'm not sure if this is the case, but it feels like if I perform some task in `loop()` that takes some time to finish (but only needs to be done once…
-
I am sending ckb using the sendtransaction function of ckb-sdk-js.
However, sending the same amount to the same address within a short period of time will result in a depulicate transaction error. …
-
Hello,
If I generate obfuscated scripts on my desktop, then transfer them to a pi, i'm unable to run them on the pi. Since pyarmor is using ctypes i'm guessing it's due to an architecture difference…
-
Hi, I flashed a Pro Micro with the sketch but when plugged into pc it just connects shows briefly then disconnects. This continues to happen. Do you know the correct wiring for pro micro ? Also I have…
-
Hello,
Im having a problem with the cells.forEach function.
With the old api I used :
> const doc = new GoogleSpreadsheet('sheet_id')
await promisify(doc.useServiceAccountAuth)(creds);
const i…
-
Is it enough to connect TX pin 2 on EMU Exp port and GND or also connect RX for handshake ? Cant see any handshake in the code though. Have made a new struct file on my fw 1.207 in EMU. Have also test…
-
When I am fast switching between a number of tabs containing CMD and Powershell, you will get a crashed emoji graphics
Looking to the dev tools it comes from the xterm overlay:
```
…
-
I use influxdbV1 with batch writing, Writepresision::MS (or NS/US for that matter)
influxdb client library V3.2
ESP8266 board 2.7.1
And a HX711 with the latest library on pins
const int LOADCELL…
-
Load values should be allowed to be negative. It is possible for the loadcells to sense in either tension or compression so both positive and negative numbers are required
Load offset should be al…
-
This code work perfect, calibrating i so easy.
After I calibrated the calFactor using examples/Calibration.ino, its save to eeproom.
And i just run another examples and get calFactor from eeprom…