-
At the moment, list of signal phases is hardcoded. This should be more dynamic by reading the actual applicable ones from the IC4 .8SD config file.
Example of how this looks in the file itself:
[P…
-
At present, the detector names are hardcoded into the application. Ideally, the detector names should be taken from the IC4 controller config file.
Example from the .8SD file (where items in bold r…
-
I personally think that the IC4 and its wagons are defenetly too long for Traincraft, it should be shortened to the lenght of the other locos / hitboxes should be changed so the train doesnt seem to d…
-
@jordens The routing is done. It is still preliminary. Once you accept it, I will finish cosmetics, pour polygons and start PI & SI & Thermal analysis. The bottom side of the PCB below DDS chips is fr…
-
The following comments pertain to ADC_channel.SchDoc on PCB_mezzanine_analog_allaki. Recall that discussion of specification for allaki analog input is #81. Note that existing Issue #79 is design rev…
-
- [x] Can you put titles on each page, so it's easier to track what's going on when reading the schematic?
- [x] There are a few bits of overlapping text (e.g. component values). Just needs a bit of …
-
Hello,
I found out that the BOM list, genretated in Eagle, is not ok in version 4 and 3! (maybe other versions too)
Is there somewhere a good list.
Regards, Michel
-
Thanks for posting the updated Urukul schematic @gkasprow! Starting a review of it...
- [x] DDS_CLK1_P/DDS_CLK1_N and similar for other DDSs should be zero-indexed
- [x] RFSW_CTRL_1 etc should be …
-
As pcb/kicad4 is hand-copied version of pcb/kicad, it also contain the design issue described below.
![lm6551](https://cloud.githubusercontent.com/assets/766864/21759026/50123458-d684-11e6-9ac9-bbc…
muojp updated
7 years ago
-
access to reset switch obstructed by display board.
Front pannel bottom screws misregistration difficulties to allign threaded part with the case.
Unkeyed and unmarked pin connectors no easy way to …