-
^C (on serial) does not seem to have any effect whatsoever in ash or sash.
Only as 'line kill' in linenoise.
--Mellvik
-
HI! I'm a new genmon user, only a couple weeks now. I'm using a Pi Zero W with a USB attached WiFi and external antenna. Maybe some photos of the build later.
I recently did some work to get the…
-
After using GGS for a few days, I am quite impressed with the quality of it. Very well done. Program limits are a useful feature. I could have used this a couple of times in the past. Even with the ar…
-
I've seen this problem on two very different XT machines: Turbo-XT with 8bit ISA card (two bare 8250's on it) and Amstrad PC 2086 (on-board Amstrad 40049 UART, the same as in Amstrad Portable PC model…
-
### Bug Report
I'm using Marlin v1.1.6 with RAMPS 1.4 with full graphic Smart Controller. I've changed from a thermistor to a thermocouple K-type using a MAX6675. I've changed the sensor type to -2 i…
-
hi to all
am i using a cyclops extruder with two stepper motor that they push the two filaments in to the cyclops extruder.
the problems are:
1)if i set 2 extruder with single nozzle function,it'…
-
14. CONSERVATION FUNCTION
14.1. At the level of landscapes and ecosystems (including soils, water and climate):
- [x] 14.1.1 Describe and give the location of ecosystems and/or land cover types …
-
### Bug Report
**- Description:**
After issuing the `G29` command to use the Bilinear Leveling feature, the printer does not react to either the `M851` command nor to a change in the `Z_PROBE_OFFSET…
-
Hello embedded Rustaceans!
We are collecting a "wishlist" of things you'd like to see done, fixed or
stabilized in 2019. We'll use this data to make a roadmap for 2019, i.e. to set
the goals of t…
-
Hi there new to marlin and working with a MKS Gen 1.4 and been doing good on it, Got it all working and I noticed after testing the hotend and heatbed for stability for an hour, I looked at the LCD an…