-
Hi, when using the CNC post-processor of FreeCAD you also provide i realised, that arcs `G2` and `G3` are not supported. I read that your Fusion360 post-processor breaks the arcs into linear moves `G1…
-
### Is your feature request related to a problem? Please describe.
Hello, looking at the new animation system, I see one issue that might be resulting to the walking animation looking a bit odd.
W…
-
This will likely need some changes the the ASMBL parser too
-
### Which component impacted?
Encode
### Is it regression? Good in old configuration?
None
### What happened?
I am using some YouTube clips to test 8k -> 4k encodes and the overall best encoding …
-
With linear paths, one must theoretically come to a complete stop at each joint in order to avoid straying from the path. If these joints are turned into curves (essentially an arc of a circle where t…
-
-
I am running 0.9j with this settings
$0=10 (step pulse, usec)
$1=0 (step idle delay, msec)
$2=0 (step port invert mask:00000000)
$3=0 (dir port invert mask:00000000)
$4=0 (step enable invert,…
-
I have connected 2 end stops for each axis. Both the movements and the end stops works fine when jogging. But when i home ($H) all motors lock up and nothing happens - except for a high pitch noise fr…
-
I've come to look at undesired resonances at certain speeds with my CoreXY printer (using Klippain macro) and now that I got rid of all unwanted motion speeds in the speeds settings in Superslicer, th…
RURon updated
3 months ago
-
Arc Welder turns the corners it straight lines.
[Block Spacer_single.zip](https://github.com/FormerLurker/ArcWelderPlugin/files/5974850/Block.Spacer_single.zip)