-
i have plans to test you stack in our LoRaWAN module, the LSI110A
it's is a STM32WL55+SX1262 :)
-
I am brand new to this and I purchased a ANET A8 that was DOA. I purchased a mks gen 1.4 board and a mks mini12864 v1.0 & a mks tft32 w/ wifi. (I am not a coder/programmer)
I was able to get the mi…
rnx22 updated
2 years ago
-
One of the Y axis moves slower than the other causing issues during prints. I have no clue where to go from here.
`/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https:…
-
Hi,
I am developing my own app therefore I am rebooting the vobot many times. Every so often I am getting the following error that forces me to reboot the device again.
D (3692) NTP: sync time fr…
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…
-
All flight stack related applications, support libraries, and irrelevant testing, post-processing, and example scripts need to be removed. This issue can only be closed after we have successfully buil…
-
Hi,
I'm using mk4duo 4.3.2. I have a bltouch clone. I set it up as blotuch sensor (couse if not, then it leaves the tip out when moving the next calibration point).
Sometimes when measuring a ca…
-
Hi . I wired everything like shown up but get TMC Connection Error in Display. Checked via Pronter 3 TMC2008 get a Connection But the 4. Has bad Response All to low. Can sw Help pls . I used BT…
-
I made a post in the main branch of [Marlin](https://github.com/MarlinFirmware/Marlin/issues/22996) & another user [here](https://github.com/bigtreetech/SKR-2/issues/96) has a similar issue.
What I…